Looking for a fun weekend project? Discover the OXO QRP transmitter—an elegantly simple, high-performance HF rig perfect for homebrew enthusiasts and minimalist radio operators
Circuits
The Circuits category focuses on stand‑alone electronic building blocks that power your radio and audio projects: amplifiers, oscillators, filters, keyers, indicators, test jigs, and more. Instead of full transceivers or big systems, you’ll find focused designs like microphone preamps, push‑pull HF linear amplifiers with IRF510, regenerative receivers, short‑wave transmitters, low‑battery indicators, and timing circuits
Simple audio compressor for SSB HF Radio rigs
Simple audio compressor for SSB HF Radio rigs An audio/speech compressor is a device that reduces the dynamic range of the audio signal. This means that it makes the loud parts of the signal quieter and the quiet parts of the signal louder. This can be useful for SSB HF radio rigs because it can […]
NE555 based Microphone amplifier
NE555 based Microphone amplifier IC NE555 or commonly known as 555 is an IC that is well known among electronics practitioners as an IC for timers, and can be used to form monostable or bistable multivibrator circuits. But not many know that the 555 IC can also be used as an audio signal amplifier. By […]
LM324 microphone speech compressor
Stop fading into the noise! Build this simple, low-cost speech compressor using the LM324 quad op-amp to ensure your voice stays loud and clear on the airwaves.
Amateur Radio – Mike Preamplifier/Speech compressors/Audio Processors – Resources
Audio processors and Speech compressors are important in SSB radio because they can help improve the transmitted signal’s quality. Here are complete resources and links available in the internet connected to Mike Preamplifier/Speech compressors/Speech Processors Dyna Audio compressor Noise Canceling Electret Microphones – WB9YBM Microphone Speech Processor Microphone Amplifier with ALC Audio compression with transistors […]
Really Cheap audio compressor
This article presents a simple, low-cost audio compressor circuit designed to stabilize microphone signal levels. It reduces dynamic range by softening loud sounds and boosting weak ones, improving clarity and intelligibility. Built with basic components, it suits amateur radio and DIY audio setups, offering consistent output without complex or expensive hardware.
SSM2167 audio processor for Baofeng Mic enclosure
SSM2167 audio processor for Baofeng Mic enclosure Mic gain is barely adequate on the µBITx transceiver since there is no Mic Gain control. It would also be helpful to not only provide mic gain control, but to add compression in order to boost the average power output.The SSM2167 is a powerful audio processor that can […]
Simple mic compressor using 3 Transistors for HF rigs
This article describes a simple microphone compressor built with three transistors to improve audio consistency. The circuit uses a preamplifier, buffer, and feedback stage to control gain. As input increases, negative feedback reduces amplification, compressing louder signals. It runs on 12V and suits amateur radio setups needing stable, balanced voice output.
SSM2167 Microphone Preamplifier with compression for ubitx HF Transceiver
This project uses an SSM2167 IC as a complete microphone preamplifier with built-in compression and noise gating to improve uBITX transceiver audio. It boosts mic gain, reduces dynamic range, and suppresses background noise, resulting in clearer, louder, and more consistent transmitted speech.
Ribless Programming cable for Motorola GM360/GM338 radio
This article explains how to build a low-cost ribless programming cable for Motorola GM360, GM338, and GM300 radios. It uses a USB-to-TTL adapter, RJ45 connector, and a diode to enable direct serial communication without a RIB unit. The guide covers wiring, setup, and software configuration for reliable radio programming.